Kenwood Ham Radio System

$600 for all, will not separate, good working condition. Buy them individually is $1300. Kenwood AT-200 The Kenwood AT-200 antenna tuner covers 6 amateur bands from 1.8 to 30 MHz with easy to use controls. Through power is 200 watts maximum. It has power scales for 20 and 200 watts. There is a built in SWR meter. The rear panel has: Input is SO-239 [UHF]. Antenna Output 1 is SO-239 [UHF], Antenna Output 2 is SO-239 [UHF], Antenna Output 3 is wire connection and ground. The AT-200 is a perfect match with the TS-820S series. Physical: 7.2 x 5.3 x 11.5 inches 7.5 lbs. (180x133x287mm 3.4 kg). The Kenwood TS-440S was designed for superior performance in the the SSB, CW, AM, FM and AFSK modes. Full and semi CW break-in is supported. The 100 memories store frequency, mode and band are are divided into ten banks of ten channels each. Memory and band scanning are both available with adjustable scanning speed. Coverage is 160 through 10 meters including the WARC bands with final input power of 200 watts SSB/CW/FM/ AFSK and 110 watts AM. Final output power approximately 100W (40W AM). Requires 13.8 VDC at 20.5 Amps. MC-43S hand mic included. The Kenwood PS-430 power supply provides 13.8 VDC at 20 Amps intermittent (25% duty cycle), 15 Amps standard (50% duty cycle) or 10 Amps maximum at continuous load. Ripple voltage is less than 20 mW at 13.8 VDC 15 A. Input is 120/220/240 VAC 480W. The power supply employs a 6 Amp AC fuse and 20 Amp DC fuse. Kenwood YK-88A-1 AM filter. It is the plug in type the will work in the R5000, TS930, TS940, TS850s, TS450, and so on MFJ-945e Mobil Tuner Covers 1.8 to 60 MHZ, f6-meter band and has antenna bypass Switch! Dont go mobile without it! Dont leave home without this