Photo of (Sale Pending) Utility Trailer Truck Box
$1800
(Sale Pending) Utility Trailer Truck Box
If this ad is up, then item is still available! For Sale: Used utility trailer made from a heavy half ton or 3/4 ton truck box when the DVM allowed such ones to be built from. Single axle with functional tail gate made from a 1975-78 truck box and frame. It has a hitch for a 2” ball, functioning factory lights (4 ways, brake & signal lights) just like it was a functioning truck(no aftermarket lights or brackets to mess with. Tires are ok for now, 15” 5 bolt rims on the trailer with an additional set of rims to go with trailer. I have a brand new jack stand to go with as well but have not been welded it on yet. Hitch secure chains included as well as a brand new trailer plug installed, as the last one corroded from sitting too long. No padlocks or hitch locks included in the sale. Trailer bed has got some surface rust and can be cleaned up with a wire brush or sand blaster and resurfaced with tremclad paint or a rubber coating. Pulls very nicely on the highway or gravel roads. This trailer is useable now, registered, serial numbered and plated by me and can be delivered to you for a small fee within the Southern Alberta area Asking $1800 (sale pending) No trades, reasonable offers maybe considered, low ballers will be ignored. Cash, bank draft, money order, or e-transfer accepted (Emt accepted before pickup of trailer, not on my driveway) Sale of trailer within Canada only
categories:Auto and TrailersUtility Trailers
809 impressions
158 views
Lethbridge, AB3 weeks ago
Photo of 120 Horsepower Fishing Setup 1972 17.5" Fiberform Inboard Motor Boat with Full Enclosure Canopy
$3750
120 Horsepower Fishing Setup 1972 17.5" Fiberform Inboard Motor Boat with Full Enclosure Canopy
For sale is our loved "Jolene", as we have bought another boat with a cabin to fare a bit better on the high seas. Comes with E-Z loader trailer with a spare tire, 2" ball and 4-pin flat electrical hookup. All registered. Body: 17.5 foot Fiberform by Canadian Fiberform Ltd., Canadian made in Kelowna. This old gal has been a loyal B.C. local her whole life since she was registered in 1972. The fiberglass is still strong with minimal bruises - a new paint job might breathe a bit more life into 'er. Perks include a rear port kicker mount and spacious glovebox. Seats: 6 seats total – the front 4 fold down to make bench seats if desired (with small storage compartment underneath either way) and the rear 2 have substantial storage. One is fully available, the other has dual battery system within taking up about half of it. Upholstery generally strong with some expected wear and tear. Canopy: Full enclosure with see-through poly window for convenient navigation in cold, wet, or rainy conditions. Front flap zipper allows for convenient access to the bow to stow ropes/crab traps, get a better view, or re-enact the scene from Titanic where Jack and Rose stand at the front of the ship. (Re-enacting other scenes from Titanic not recommended). Side zippers allow the entire rear to be taken off for fishing or recreating, while keeping the front in place. Far more extensive and customizable than a bimini top. Engine: 120 HP OMC Stern Drive gasoline inboard, model no. CUFM19EX. She's old but true; reliable start even from cold on a well-charged battery; ether occasionally comes in handy after winter but usually not necessary. Could use a good carb clean/tune, and the belt is starting to look rough. To Oil can never be changed too often. Fishing hardware: -2x old fashioned scotty downrigger mounts with 2x rod holders, -1x Scotty 26" manual downrigger and mount with bar-mounted rod holder, -mounted sonar transducer + 7-pin cable for GPS, -3' retractable rope landing net. Misc items: 3x adult lifejackets, 1x boat emergency kit/bailer, 2x emergency oar, 1x spare propeller, 1x fire extinguisher, 15 lb anchor on 100" line with steel chain leader, light mud anchor, ~1L 5w30 full synthetic premium engine oil, ~500mL marine leg oil "Type-C". Recent work done: Installation of dual battery system and switch to run on either or both, or switch off power completely to prevent drainage by auxiliary systems like sonar/fish finder. New starter. New leg lifting (up) solenoid. Reinforcement of downrigger mounts for stability and longevity. Re-stitching of canopy for increased durability. Replaced horn system. Installation of new sonar transducer. Optional (can be worked into the deal): -Large crab pot with sinking line and buoy, $75 -Lowrance Elite 4 Chirp GPS, $300 -1x nearly new Cannon 1901020 downrigger/rod holder combo (used 4 times) $200 -1x 2017 Coleman 5 hp 4-stroke outboard kicker (less than 20 hours runtime) $850
categories:Sporting GoodsBoats
6708 impressions
713 views
Vancouver, BC7 months ago
Location
Search within
of
Categories

Other
Medical Equipment

Transportation options

Local Pickup7Can Deliver2Can Ship2